Page 825 - 5G Basics - Core Network Aspects

Transport aspects 2

Table 11-9 – OLR commands sent by the initiating FTU

Name Length (bytes) Byte Content Support
A variable number of bytes describing
subcarrier parameter field for each
subcarrier.
2 0416 (Note 1)
3 Segment code (SC)
4 [0000 aaaa]
aaaa = RPA configuration change count
OLR request type

4 (update RMC
8+2 × NSCR Mandatory
parameters) 5 and 6 Two bytes for the number of subcarriers of
(RPA) the updated RTS (NSCR).
7 and 8 CNTSF at which new settings to be applied.
9 to 9 + 2 × 2  NSCR bytes describing the subcarrier
NSCR − 1 parameter field for each subcarrier.
2 0516 (Note 1)

3 and 4 Downstream RMC transmission schedule
represented as a bit map:
0 – indicates an inactive TDD frame
1 – indicates an active TDD frame
The LSB of byte 4 corresponds to the TDD
sync frame (index 0). The MSB of byte 4
corresponds to the TDD frame with index 7.
The LSB of byte 3 corresponds to the TDD
OLR request type frame with index 8 (see clause 10.6). Bits
5 corresponding with an index ≥ MSF shall be set
(L2TSA: L2 7 to 0. Mandatory
transmission 5 and 6 Upstream RMC transmission schedule
schedule represented as a bit map:
adaptation) 0 – indicates an inactive TDD frame
1 – indicates an active TDD frame
The LSB of byte 6 corresponds to the TDD
sync frame (index 0). The MSB of byte 6
corresponds to the TDD frame with index 7.
The LSB of byte 5 corresponds to the TDD
frame with index 8 (see clause 10.6). Bits
corresponding with an index ≥ MSF shall be set
to 0.
7 [0000 aaaa]
aaaa = L2 configuration change count (L2CCC)
NOTE 1 – All other values for this byte are reserved by ITU-T.
NOTE 2 – Setting bb=00 is only valid for a TIGARESP (see clause 13.2.2.1).
NOTE 3 – Setting N f = 0 is valid and shall be used if the OLR command of OLR request type 2 is confirming the settings requested
by TIGA.
NOTE 4 – If used in the upstream direction, OLR request type 1 can only be used as an autonomous SRA or bit swapping and
d_SRA shall be set to 1. It is implied that all gains g i will remain unchanged.
NOTE 5 – If used in downstream, all gains shall be set to 1. It is implied that d_SRA =1.
NOTE 6 –The b i values indicated in the NOI subcarrier parameter block shall not be applied to RMC subcarriers.

815