1 Scope
2 References
3 Definitions
4 Abbreviations and acronyms
5 Conventions
6 General introduction to packet-based time/phase distribution
6.1 Requirements for packet-based time and phase distribution
7 Architecture of packet-based time/phase distribution
7.1 Packet-based time and phase distribution
7.2 Time/phase protection aspects
7.3 Packet network partitioning
8 Security aspects
9 Management aspects
Annex A – Time/phase models based on ITU-T G.805
Annex B – Inclusion of an external phase/time interface on a PTP clock
Appendix I – Architecture for time and phase distribution over a packet network
providing partial timing support at the protocol level
I.1 Architecture for partial timing support
Appendix II – An example of PRTC switching by the BMCA in a ring network
Appendix III – Generic IWF PTP clock
Appendix IV – Use cases for mapping from PTP clockClass values to quality
levels
IV.1 Use case I
IV.2 Use case II
Appendix V – Deployment examples and the use of partially
aware clock types
Appendix VI – cnPRTC functional architecture
VI.1 Introduction
VI.2 cnPRTC functional architecture
Bibliography