1 Scope
2 References
3 Definitions
4 Abbreviations and acronyms
5 Conventions
6 Frequency accuracy
6.1 Option 1
6.2 Option 2
7 Pull-in, hold-in and pull-out ranges
7.1 Pull-in range
7.2 Hold-in range
7.3 Pull-out range
8 Noise generation
8.1 Wander in locked mode
8.2 Non-locked wander
8.3 Jitter
9 Noise tolerance
9.1 Wander tolerance
9.2 Jitter tolerance
10 Noise
transfer
10.1 Option 1
10.2 Option 2
11 Transient response and holdover performance
11.1 Short-term phase transient response
11.2 Long-term phase transient response (holdover)
11.3 Phase response to input signal interruptions
11.4 Phase discontinuity
12 Interfaces
Appendix I – Hybrid network elements using STM-N and Ethernet (ETY)
interfaces
Appendix II – Relationship between requirements contained in this
Recommendation and other key synchronization-related Recommendations
Appendix III – List of Ethernet interfaces applicable to synchronous
Ethernet
Appendix IV – Considerations related to synchronous Ethernet over 1000BASE-T
and 10GBASE-T
Appendix V – Considerations for measuring noise
transfer for Option 2 clocks
Appendix VI – Considerations for testing of
pull-in range
Appendix VII – Performance estimation for cascaded media converters acting as
synchronous equipment clocks
VII.1 Noise generation
VII.2 Noise tolerance
VII.3 Noise transfer
VII.4 Transient response and holdover performance
Bibliography