Recommendation ITU-R SM.2060-0(08/2014) Test procedure for measuring direction finder accuracy
Foreword
Policy on Intellectual Property Right (IPR)
Scope
Keywords
Annex 1 Measurement techniques of ultra-wideband transmissions
TABLE OF CONTENTS
1 Introduction
2 Definition of test conditions
     2.1 General considerations for OATS
     2.2 Test frequency selection
          2.3 Test equipment settings
     2.4 Test site selection
     2.5 Test azimuth angle layout
     2.6 Test data collection
     2.7 Test data evaluation
          Note that the ( is bearing error for each measurement. It is calculated as the difference between the true azimuth and the displayed bearing on the DF equipment.
     2.8 General considerations for anechoic chambers
     2.9 Antenna polarization
     2.10 Additional considerations for HF DF measurements
3 Special considerations for mobile DF systems
     3.1 Considerations for mast and roof mounted mobile configurations
     3.2 Power source installation considerations
4 Alternative measurement method using a multipath simulation