CONTENTS

PART 1
 1     Introduction
 2     Assumptions for ATSC 3.0
        2.1     Lab Performance – Demodulator
        2.2     Lab Performance – System
 3     Description of the laboratory measurements done to define the method
        3.1     Laboratory Performance – Demodulator tests
                  3.1.1     Frequency pull-in range
                  3.1.2     Modes of configuration
                  3.1.3     Impairment paths
                  3.1.4     Peak-to-average power ratio
                  3.1.5     Single frequency network (SFN)
        3.2     Laboratory performance – system tests
                  3.2.1     Automatic gain control (AGC) dynamic range
                  3.2.2     Frequency range
                  3.2.3     Phase Noise
                  3.2.4     Impulse noise
                  3.2.5     AWGN with power levels: weak, moderate, strong
                  3.2.6     Interference with adjacent channel interference, co-channel interference and others
 4     References
PART 2
 1     Introduction
 2     Background
 3     Test objectives, scenarios and signal types
        3.1     Coverage testing objectives
        3.2     Service testing objectives
        3.3     Channel characteristics testing objectives
        3.4     Single frequency network testing objectives
        3.5     ATSC 3.0 reception scenarios
                  3.5.1     Fixed outdoor
                  3.5.2     Fixed indoor
                  3.5.3     Portable
                  3.5.4     Pedestrian
                  3.5.5     Mobile
        3.6     Test signal types
 4     Test measurement methodology and procedures
 5     References