Preface
1
Procedures for the establishment of a national Access Information Path
(AIP) between a G3 facsimile equipment (G3FE) and an FPAD
1.1 Access from a G3 facsimile equipment to an FPAD
1.2 Access from an FPAD to a G3 facsimile equipment
1.3 Manual operation both at the emitting and receiving G3
facsimile equipments
2
Procedures for service initialization between a G3 facsimile equipment
and an FPAD
2.1 Exchange of control information between a G3 facsimile
equipment and an FPAD
2.2 Procedures for initialization
3
Procedures for the exchange of control information between a G3
facsimile equipment and an FPAD
3.1 General
3.2 Procedures for virtual call control
3.3 Procedure for FPAD commands
3.4 Formats of FPAD command signals and FPAD service signals
4
Procedures for the exchange of facsimile image data between a G3
facsimile equipment and an FPAD
4.1 Facsimile procedure (state 5)
4.2 Receiving capability notification in DIS or DTC command
4.3 Non-standard facilities
4.4 Procedure upon receipt of procedure interrupt command or
response
4.5 Determination of data signalling rate
4.6 Facsimile image data from the G3 facsimile equipment received
by the FPAD
4.7 Delivery of user data to the G3 facsimile equipment
4.8 Data forwarding conditions
4.9 Procedure for the FPAD to indicate to the G3 facsimile
equipment a temporary inability to accept additional information
Annex A – FPAD command signals and FPAD service signals
Annex B – FPAD time-outs
Annex C – State diagrams
Annex D – Support of non-standard facilities
Annex E – Access to MHS
E.1 Introduction
E.2 References
E.3 Principles of the enhancements of X.38 to allow MHS access
E.4 Message-submission operation
E.5 Message-delivery operation
E.6 Command operation
E.7 Report operation
E.8 Facility block and address block
E.9 Table of the facility request codes
E.10 Specific FPAD service signals for MHS access
Annex F – Alphabetical list of abbreviations used in this
Recommendation
Appendix I – Examples of event sequence