CONTENTS

 Introduction
1)     Table 6.3, Timing for activation signals
2)     Clause 6.2.2.1, Signal Cr
3)     Clause 6.2.2.8, Exception state
4)     Clause 6.3.2.1, Signal Pri
5)     Clause 6.3.2.2, Signal Pci
6)     Clause 6.4.1, G.994.1 code point definitions
7)     Clause 7.1.2.5.3, fbit3 = ps (power status)
8)     Clause 9.2.7, Loss of sync word failure (LOSW failure)
9)     Clause 9.5.5.4, Frame check sequence
10)     Clause 9.5.5.7.2, Discovery response – Message ID 129
11)     Clause 9.5.5.7.4, Inventory response – Message ID 130
12)     Clause 11.4.2, Test circuit calibration
13)     Clause 11.4.3, Total transmit power requirement
14)     Clause A.3.1.3, Calibration measurement of crosstalk generator
15)     Clause A.4, PSD masks
16)     Clause A.5.3.3, Wetting current
17)     Clause B.3.2, Test set-up definition
18)     Clause B.3.5.2, Cable crosstalk models
19)     Clause B.3.5.4.1.1, Self crosstalk profiles
20)     Clause B.3.5.6, Measurement of crosstalk noise margin
21)     Clause B.4.1, Symmetric PSD masks
22)     Figure B.7, PSD masks for 0 dB power backoff
23)     Figure B.8, Nominal symmetric PSDs for 0 dB power backoff
24)     Clause B.4.2, Asymmetric 2.048 Mbit/s and 2.304 Mbit/s PSD masks
25)     Figure B.9, PSD masks for 0 dB power backoff
26)     Clause B.5.2, Return loss
27)     Clause B.5.3.2, Power feeding of the STU‑R
28)     Clause E.4, TPS-TC for aligned DS1/fractional DS1 transport
29)     Clause E.7, TPS-TC for aligned European 2048 kbit/s digital structured leased line (D2048S) and fractional
30)     New Clause E.9.2.3, IMA using the ATM TPS-TC (Informative)
31)     Clause E.10.2, Dual bearer mode types
32)     Table E.22, Supported TPS-TCs in dual bearer mode
33)     Appendix II – Typical characteristics of cables
34)     Tables II.1, II.2, II.3, II.4, II.5, II.6 and II.7 – Parameters of cables
35)     Appendix IV, Bibliography