1 Scope
2 References
3 Definitions
3.1 Terms
defined elsewhere
3.2 Terms
defined in this Recommendation
4 Abbreviations
and acronyms
5 Conventions
6 Physical layer
frequency performance requirements
7 Performance
requirements for T-BC-A and T-TSC-A
7.1 Frequency
accuracy
7.2 Time
error noise generation
7.3 Noise
tolerance
7.4 Local
time reference (1PPS) to PTP and local time reference (1PPS) to 1PPS noise
transfer
7.5 PTP
output and 1PPS output transient response (short term) due to loss and
restoration of local time reference (1PPS) input
7.6 Holdover
performance
8 Performance
requirements for T-BC-P and T-TSC-P
8.1 Frequency
accuracy
8.2 Time
error noise generation
8.3 Noise
tolerance
8.4 Noise
transfer
8.5 Transient
response (short-term)
8.6 Holdover
performance
9 Interfaces
9.1 Phase
and time interfaces
9.2 Frequency
interfaces
Annex A – T-TSC-A and T-BC-A functional model
Annex B – T-TSC-P and T-BC-P functional model
Appendix I – Consideration of slave clocks embedded in
end applications
Appendix II – Consideration of variable temperature
testing
Appendix III – Consideration of the use of a
synchronous equipment clock to maintain time holdover for partial timing
support networks
Appendix IV – Use of a synchronous equipment clock to
assist a PTP time lock
Appendix V – Synchronization interworking function P-F
node limits
Appendix VI – PTP noise tolerance testing for PTS and
APTS clocks
VI.1
Testing set-up for PTP noise tolerance testing
VI.2 Statistical
PDV model
VI.3 Parameters
for the PDV model
VI.4 Different
requirements for APTS and PTS models
VI.5 Example
delay patterns
VI.6 Output
requirements
Appendix VII – Analysis of conversion of network
limits to equipment specification for APTS
VII.1 Total
noise budget between network limits
VII.2 Holdover
operation
VII.3 Transient
operation and switching
VII.4 Dynamic
noise accumulation for APTS
Appendix VIII – Analysis of conversion of network
limits to equipment specification for PTS
VIII.1 Total
noise between network limit C and network limit D
VIII.2 Holdover
operation
VIII.3 Transient
operation and switching
VIII.4 Dynamic
noise accumulation for PTS (constant temperature)
Bibliography