1 Scope
2 References
3 Definitions
4 Abbreviations and acronyms
5 Conventions
6 Frequency accuracy
7 Pull-in, hold-in and pull-out ranges
7.1 Pull-in range
7.2 Hold-in range
7.3 Pull-out range
8 Noise generation
8.1 Wander in locked mode
8.2 Non-locked wander
8.3 Jitter
9 Noise tolerance
9.1 Wander tolerance level 1
9.2 Wander tolerance level 2
9.3 Jitter tolerance
10 Noise transfer
11 Transient response and holdover performance
11.1 Short-term phase transient response
11.2 Long-term phase transient response (holdover)
12 Interfaces
Appendix I – Relationship between requirements contained in this Recommendation
and other key synchronization-related Recommendations
Appendix II – List of Ethernet interfaces applicable to synchronous
Ethernet
Appendix III – Considerations related to synchronous Ethernet over 1000BASE-T
and 10GBASE- T
Appendix IV – Performance estimation for cascaded media converters acting as
enhanced synchronous equipment clocks
IV.1 Noise generation
IV.2 Noise tolerance
IV.3 Noise transfer
IV.4 Transient response and holdover performance
Appendix V – Example for short-term phase transient response
Bibliography