Policy on Intellectual Property Right (IPR)
Annex 1 Protection criteria of radiocommunication services operating below 30
MHz
Annex 2 Examples of national regulations
Appendix 1 to Annex 2 United States of America Regulation of RF
emissions from power line communication systems in the United States of America
1 Introduction
2 Definition of BPL
3 Emission limits
4 Special frequency protections
4.1 Frequency band exclusions
4.2 Geographical exclusion zones
4.3 Consultation area requirements
4.4 Consultation area notice
requirements
4.5 Public safety licensee notice
requirements
5 Interference mitigation
5.1 Interference complaint
procedures
5.2 Adaptive interference techniques
5.3 Access BPL database requirements
6 Measurement guidelines
6.1 Existing measurement
requirements
6.2 New/modified measurement
requirements
7 Equipment authorization
8 Conclusion
Appendix 2 to Annex 2 Germany
Annex 1 to ECC Recommendation (05)04 Guidelines for the assessment of
radio interference cases caused by disturbing radiations generated by wire-line
telecommunication networks
Explanation of flowchart
Unresolved
interference complaint
Interference resolution
Compliance investigation
Addendum to Annex 1 of ECC Recommendation (05)04 Explanation of flowchart in
Annex 1 to ECC Recommendation (05)04
Annex 2 to ECC Recommendation (05)04 Mitigation techniques and considerations,
including limits of the disturbance field strength, applicable to blocks 3 and
4 of flowchart in Annex 1 to ECC Recommendation (05)04
1 Technical aspects
2 Economic and political aspects
3 Regulatory aspects
4 Assessment of all criteria and
circumstances
Appendix 3 to Annex 2 Japanese regulations for the power line high data
rate telecommunication systems
1 Fundamental principle
2 Equipment allowed to be used: In-house
PLT equipment only
3 Limits
3.1 Conducted emission at the mains port
3.2 Conducted emission at the telecommunication
port
3.3 Radiated emission
4 Derivation of the limits
4.1 Procedures
4.2 PLT installation model and draft limits
4.3 Japanese PLT limits
5 Measurement conditions for the PLT
common-mode current
Appendix 4 to Annex 2 Federative Republic of Brazil Brazilian
regulation on power line high data rate telecommunication systems
1 Introduction
2 General requirements
3 Measurements
4 Specific requirements
4.1 Frequency band exclusions
4.2 Exclusion zones
4.3 Preventive action
4.4 Coordination process
5 Conclusion
Appendix 5 to Annex 2 Republic of Korea
1 Limits
1.1 Limits for conducted emission at
power ports
1.2 Limits for radiated disturbance
1.3 The prohibited frequency band as
use of PLT
2 Measurement method of radiated
disturbance
2.1 Measurement methods in frequency
range 9 kHz to 30 MHz
2.2 Measurement methods in frequency
range 30 MHz to 1 000 MHz