CONTENTS

Policy on Intellectual Property Right (IPR)
Annex
 1     Introduction
 2     Terms and definitions for the purpose of this Recommendation
        2.1     Antenna diagram for fixed reception
        2.2     Antenna factor
        2.3     Assignment area
        2.4     Bit error ratio
        2.5     Cell
        2.6     C/N
        2.7     Coverage area
        2.8     Service area
        2.9     Coverage prediction
       2.10     Crest factor
       2.11     Guard interval
       2.12     Height loss
       2.14     Median
       2.15     Minimum median field strength (E_med)
       2.16     MFN
       2.17     Minimum equivalent signal level
       2.18     Minimum wanted (equivalent) field strength (E_min)
       2.19     Network gain
       2.20     Protection ratio
       2.21     Quasi error-free reception
       2.22     Receiving field strength
       2.23     Receiving scenario
       2.24     Reception channel
       2.25     The GE06 Agreement
       2.26     Self-interference inside an SFN
       2.27     Single-frequency network
       2.28     Standard deviation
       2.29     Standard deviation of the spectral amplitudes (σ_sp)
       2.30     σ_sp‑correction (C_σ)
       2.31     Small area
       2.32     Substitution transmitter
       2.33     System variant
       2.34     Wanted field strength
 3     Measurement methods
Attachment 1  Verifying the coverage prediction for fixed reception
       A1.1     Selection of measurement locations
       A1.2     Necessary measurement equipment
       A1.3     Measurement procedure
                  A1.3.1     Wanted signals
                  A1.3.2     Unwanted signals
       A1.4     Evaluation of the results
                  A1.4.1     Verifying homogeneous field strength distribution
                  A1.4.2     Correction for the reception channel
                  A1.4.3     Correction for time probability of interfering signals
                  A1.4.4     Decision whether a measurement point is covered
       A1.5     Result presentation
       A1.6     Verification of coverage
Attachment 2  Verifying the coverage prediction for portable reception
       A2.1     Measurement principle
       A2.2     Necessary measurement equipment
       A2.3     Measurement procedure
       A2.4     Evaluation of the results
       A2.5     Result presentation
Attachment 3  Simplified method to determine the coverage border of  DVB-T/T2 transmitters and networks
       A3.1     Introduction
       A3.2     Measured parameters of the signal
       A3.3     Equipment requirements
       A3.4     Measurement planning
       A3.5     Measurement procedure
       A3.6     Processing of measurement results
       A3.7     Measurements in SFN
Attachment 4  Method to measure the coverage of DVB-T/T2 service for  fixed reception in defined areas
       A4.1     Introduction
       A4.2     Equipment requirements
       A4.3     Measurement planning
       A4.4     Measurement procedure
       A4.5     Processing of the measurements
       A4.6     Display of measurement results
Attachment 5  Required corrections of measurement results
       A5.1     Reception channel correction (σ_sp‑correction)
       A5.2     Location probability correction
       A5.3     Total correction for indoor coverage